Open ConnectBot on your mobile and connect to the Pi-Tail. Bluetooth works the other way: You have three minutes after boot up to pair with your Pi-Tail. The effective config is copied back to /boot/interfaces.active and /boot/wpa_supplicant.active for offline troubleshooting.Įnable “wifi hostspot” or “usb tethering”on your phone and the Pi-Tail should connect automatically. You can now edit the network configuration with your phone.ĭuring the boot process, Pi-Tail will pick up your network config and copy it across to the system partition.

That means it appears to your mobile phone as a usb stick. Pi-Tail checks during boot if ethernet gadget mode is enabled and if not, it will automatically switch to mass storage gadget mode. For bluetooth tethering, just add your smartphone’s mac address into /boot/nf. Just write the image to a micro-sd card, adjust /boot/interfaces and /boot/wpa_nf to fit your tether requirements, insert the card into your pi and hook it up to your mobile. The network configuration can be prepared offline making it the perfect field companion. The Pi-Tail is running Kali Linux and your smartphone acts as the power supply, screen, keyboard and mouse. Read /boot/Pi-Tail.README & /boot/Pi-Tail.HOWTO for more information and tethering options How it works: It’s still much faster to stick to the command line though.įor more info about how to tunnel a vnc connection through ssh, check out the forums: Note: Give it a few minutes when you connect for the first time. – Run “vncserver” in the Pi-Tail, fire up a vnc viewer on your phone and connect to run “airodump -i mon0”, “kismet -c mon0”, “wifite -i mon0” or anything you like.

run “mon0up” to set wifi interface into monitor mode (yes, while using it).Install Hacker’s Keyboard, ConnectBot & VNC viewer (if desired).Enable hotpot with ssid = “sepultura” and password = “R4t4m4h4tt4”.Connect: OTG adapter in smartphone, standard cable in Pi-Tail (power) to power up Pi-Tail.Download image from here and write to micro-sd card.Just install ConnectBot and VNC viewer on your smartphoneĪutomatic switch between usb ethernet and mass storage

Image, configure, connect, boot up in two minutes from scratch Two cable solution for usb tether with smartphones Simple, one cable solution for bluetooth and wifi tether Sticky Fingers Kali-Pi0 optimised for tethering 2nd December, 2017 Re4son’s Pi-Tail Kali Linux OTG for non-rooted smartphones

Kali vnc viewer